VDC would be the abbreviation for Volt Direct Current which translated would volts direct current. The idea of ??this type is unidirectional current to the load. Direct current is normally produced by batteries, thermocouples, solar cells and a dynamo electric machine type. The direct current can flow in conductors such as wires, but may also flow through semiconductors, insulators ... In the image: 1 - current per pulse 2 - Direct Current (DC) 3 - Alternating Current (AC) 4 - Variable Current

Although there are infinity tips as manufacturers or type of use, these are the most commonly tips used in the electronics industry, hardware or electricity.

1. Slot: Characterized by its flat and elongated tip.

2. Phillips: It may be the most used, its tip is shaped like a four-pointed star. Also called commonly screwdriver

3. Pozidriv: Like the previous model, but with a twist. Inside it has 4 slots in a star more.

4. Torx: Widely used in vehicles, its shape is a star with 6 points.

5. Security Torx: Same as above, but inside has a pin.

6. Hex: Point-shaped or hexagon Allen calls. Such tips are distinguished from the rest because they are able to withstand higher torque strength.

When calculating the life of a battery it will be necessary to know the number of charge cycles that can be performed until the battery does not begin to lose its capacity.
Depending on the type of battery these charging cycles can vary, the most common being the mobile batteries, manufactured Li-Ion or Li-Po, which have a duration of between 300 and 500 charging cycles according to model and manufacturer.
Once thisE limit we will notice how the battery loses duration of operation, arriving to lose up to 25% of its capacity of load.
At this point it will be necessary to evaluate a battery change.
It should be noted that usage and charging habits can significantly affect battery life. For example, factors such as heat, charge the battery several times a day without it is almost exhausted, etc. Will be affectedits duration.
Therefore, to get the most out of the battery we must know when a full charge cycle is performed, and try to avoid misuse of charge, to increase its useful life.
A charging cycle is considered when the battery has been discharged or its 100% charge has been used.
The manufacturers advise that the charge is never made below the 58% battery, since the battery voltage would not fall so lowTo, so you could end up winning up to 4000 charge cycles.
Tips to increase the life of a battery.

• Avoid extreme heat or cold or very long applications of the device.
• Charge the battery as often as you can.
• Fully discharge the battery from time to time.
• Do not let the battery run out completely before charging.

Below is a table with theDifferent voltages (V), charge cycles (C) and battery percentage (B).

It is called an rpm (revolution per minute) to the unit that is used to express the angular velocity. It is the number of complete turns a body gives around an axis.